Phase, Minimum Phase, and Group Delay

Why your EQ might be failing: Phase is the hidden variable.

What is Phase?
  1. Select Measurement Settings: Go to Options > Measurement Settings.
  2. Enable "Phase Response":** In the Spectrum view, look for the Phase graph (usually a secondary pane).
The Physics of Phase

Magnitude vs. Phase

A transfer function describes how a system changes amplitude AND phase.

Critical Rule: Two systems can have identical magnitude curves (looks exactly the same on an SPL graph) but completely different phase responses. In a loudspeaker system, this means one sounds "tight" and the other sounds "muddy," even if the frequency peaks align perfectly.

Minimum Phase

A **Minimum phase** system has the lowest possible time delay for a given magnitude response.

  • Drivers/Crossovers: Most individual drivers and passive crossovers are minimum phase. They can be inverted (flipped) without changing the frequency response, which allows for precise EQ correction of dips.
  • Room Responses: Rooms are NOT minimum phase. Reflections create complex phase interactions. Some regions are minimum phase; others are not.
Excess Phase and Group Delay

The "Excess" Concept

Excess phase** is the difference between your measured phase and a theoretical minimum phase curve.

The EQ Rule:
  • Peaks are often Minimum Phase:** If the phase is near 0 or close to minimum, a peak can be tamed by EQ.
  • Dips are often Non-Minimum Phase:** Sharp dips caused by cancellation are usually non-minimum phase. You cannot fully correct these with EQ alone; they require acoustic treatment.

Group Delay

Group delay** is the slope of the phase response graph. It shows how much each frequency is delayed relative to its neighbor.

Verification: If you draw a straight line through the Phase Response, the slope is constant. This indicates Minimum Phase behavior. Where the Phase Response curves sharply (Excess Group Delay), the system behavior is complex and harder to correct digitally.

Quiz 3

Q: Can EQ fix a sharp dip caused by cancellation if the phase response indicates non-minimum behavior?


B: No, because EQ changes signal amplitude. To fix non-minimum phase behavior (cancellation), you usually need to change room boundaries or speaker placement. (Answer: B)