Signal, Sample Rate, and Resolution
What you need to know before measuring a single frequency.
Overview: The Hardware Constraints
A measurement is not just about the room; it is fundamentally limited by your audio interface. If you do not understand the signal chain, your measurements will contain artifacts (noise or distortion) rather than true acoustic data.
1. The Signal and Sample Rate
- Select Measurement Settings: Go to Options > Measurement Settings. Set your Sample Rate. For professional work, 48kHz is standard (DVD/Blu-ray rate), though 96kHz offers more headroom for high-res DACs.
- Select Input: Ensure you are selecting the correct input channel. Do not use the built-in microphone if an external interface is available; interfaces offer better preamps and lower noise floors.
- Set Gain: Adjust the gain knob or software meters so the signal peaks around -12dBFS to -6dBFS during the sweep.
The Physics
The Nyquist Limit (Aliasing)
A **Signal** is a sequence of measurements of electrical level at the interface input. The maximum frequency you can capture depends on your Sample Rate.
- The Rule: The highest frequency captured is exactly half the sample rate (Nyquist Frequency).
- Example: At 48kHz, you can capture up to 24kHz. At 96kHz, you can capture up to 48kHz.
Warning: Frequencies above half the sample rate cause **aliasing**. The interface uses anti-aliasing filters (hardware) to reduce this. If the filter fails or is bypassed, high frequencies fold back into lower frequencies, creating phantom harmonics in your graph.
Bit Depth and Resolution
Bit depth** sets resolution.
- 16-bit vs 24-bit: 16-bit is standard. 24-bit gives lower quantization noise and better low-level detail. This is crucial for measuring room modes which often have very high Q factors (sharp peaks) where the signal gets buried in noise.
Full Scale (FS) and Clipping
Full Scale (FS)** is the largest value the interface can capture. Signals above FS are **clipped** and corrupt the measurement.
Critical Rule: If you see a flat line at the top of the RTA or a "clipped" look on the captured graph, your signal is too loud. Lower the gain immediately. Clipping introduces intermodulation distortion that ruins the Phase Response.
What the Graphs Mean
If you see a mess in your spectrum, check these three things: Sample Rate (must match settings), Input Gain (must be below FS), and Windowing (see Lesson 2).